Description

Smart IC SANSI Independent design Auto power adjustment More safety PC+Ceramics High light efficiency Super-Long lifespan Better heat dissipation Sensor Sensitivity LUX: 0-∞ LUX Time:1-10 minutes Range:0-72 ft ----- Four Kinds of Working Modes ----- TEST MODE Set-up: Put the "Mode" switch in the Test position. Function: The light turns on for only 5 seconds during daytime or night once it detects motion. This mode is used for checking whether the sensor is working properly. Test Mode can work during the daytime and night. Except for Range, the Lux and Time Setting doesn't work while using this mode AUTO MODE Motion Sensor Set-up: Put the "Mode" switch in the Auto position. Function: When the sensor detects motion, it lights up for 1-10 minutes according to the time it has been set. Auto Mode only works at night. When it's bright (> 100-150 LUX) around the sensor, the light goes automatically back to Auto Mode While using the auto mode, the toggle switches off and 2 seconds later on again. The light turns on continuously for ca. 8 hrs and goes off in the daytime. ON-TIME MODE Set-up: Put the "Mode" switch in the On-Time position. Function: Light can work as a standard LED light without motion sensing. The light turns on when switched on, and turns off when switch off. On-Time Mode can work during the daytime and night. The Lux, Time, and Range Setting doesn't work while using this mode DUSK TO DAWN MODE Set-up: Put the "Mode" switch in the D2D position. Function: The light turns on automatically at dusk or night and turns off at dawn or if it’s too bright for your sensor. D2D Mode only works at night. When it's bright around the sensor, it goes off automatically. Just r Lux Work LUX(Recommend to set LUX to 12 o'clock pos Time and Range don't work while using this mode.